TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Final Check
STALL TESTING
Stall test procedure
1. Check A/T and engine fluid levels. If necessary, add.
2. Warm up engine until engine oil and A.T.F. reach operating temperature after vehicle has been driven approx. 10 min- utes. A.T.F. operating temperature: 50 - 80°C (122 - 176°F) SAT779A Set parking brake and block wheels. Install a tachometer where it can be seen by driver during test. It is good practice to put a mark on point of specified engine rpm on indicator.
SAT597
Start engine, apply foot brake, and place selector lever in ““D”
range.
y
SAT767B8
Accelerate to wide-open throttle gradually while applying
Sy foot brake.
Quickly note the engine stall revolution and immediately
‘© release throttle. WRK
During test, never hold throttle wide-open for more than 5
seconds. Stall revolution: 2,050 - 2,250 rpm
SAT598 Shift selector lever to “N”’. Cool off A.T.F. Run engine at idle for at least one minute. . Perform stall tests in the same manner as in steps 5 through 9 with selector lever in “2”, “1” and “R”, respec- tively.
SAT771B AT-76
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.