BODY END - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › BODY END - Nissan 240SX 1991-1992 Workshop Manual
BODY END
BODY END
Body Rear End and Opener
@ Back door adjustment: Adjust at hinge-body portion for proper back door fit. @ Back door lock system adjustment: Adjust lock & striker so that they are in the center. After adjustment, check back door lock operation. @ Trunk lid adjustment:Adjust at hinge-trunk lid portion for proper trunk lid fit. @ Trunk lid lock system adjustment: Adjust striker so that it is in the center of the lock. After adjustment, check trunk lid lock operation.
WARNING:
a. Be careful not to scratch back door stay when installing back door. A scratched stay may cause gas leakage.
b. The contents of the back door stay are under pressure. Do not take apart, puncture, apply heat or allow fire near it. @ Opener cable: do not attempt to bend cable using excessive force. @ After installation, make sure that trunk lid/back door and fuel filler lid open smoothly. FASTBACK e Before removing rear bumper, remove right drafter which is secured with two upper nuts and buty] seal.
Lock nut
Fuel filler lid opener & control
[Hinge-body (Behind rear roof
rail garnish) ]a
el () 21-26 — (2.1 - 2.7, 15 - 20)
BF-6
Parts & tools for this job For Nissan 240SX
- TOOLTrim removal tool kitSearch: trim removal tool kit
- PARTTouch-up paintSearch: Nissan touch up paint
- PARTPanel clip assortmentSearch: Nissan panel clips assortment
As an Amazon Associate we earn from qualifying purchases.