TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Self-diagnosis (Cont'd)
SHIFT SOLENOID B CIRCUIT CHECK
Shift solenoid B | N.G.
CHECK GROUND CIRCUIT.
1. Remove control valve assem- > eo 1 a bly. — Refer to “‘ON-VEHI-
CLE SERVICE”.
|~— Terminal
. Check the following items. NO cord assembly @ Shift solenoid B — Refer to
2. Disconnect terminal cord 7 “Electrical Components assembly connector in engine A/T control unit Inspection’. compartment. Harness continuity of terminal @
3. Check resistance between SAT969B
cord assembly Solenoids Resistance: 20 - 402 Po harness 5 TS. O.K. connector B) i DISCONNECT Y @® €) N.G. Repair or replace harness
terminal @ and ground.
CHECK POWER SOURCE
between A/T control unit and CIRCUIT. terminal cord assembly.
1. roa
2. Disconnect A/T control unit 7 _SAT970D connector.
3. Check resistance between Solenoids Ey Vets terminal (7) and A/T control
TTT harness
TS.
unit terminal @).
Xt I connector Resistance: @ |-@ DISCONNECT Approximately 0022
4. Reinstall any part removed. O.K. v Perform self-diagnosis after N.G.
1. Perform A/T control unit driving for a while. input/output signal inspection. _/) r
2. If N.G., recheck A/T control O.K. unit pin terminals for damage Vv or connection of A/T control
INSPECTION END
unit harness connector.
[_CAUNIT [0] CONNECTOR |
7 LL L/Y
SAT971D.
AT-44
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.