Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CRANKCASE EMISSION CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CRANKCASE EMISSION CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCRANKCASE EMISSION CONTROL SYSTEM - Nissan 240SX 1991-1992 Workshop Manual

CRANKCASE EMISSION CONTROL SYSTEM

CRANKCASE EMISSION CONTROL SYSTEM

Description This system returns blow-by gas to the intake The ventilating air is then drawn from the air duct, collector. through the hose connecting air inlet tubes to The positive crankcase ventilation (P.C.V.) valve rocker cover, into the crankcase. is provided to conduct crankcase blow-by gas to Under full-throttle condition, the manifold vacuum the intake manifold. is insufficient to draw the blow-by flow through During partial throttle operation of the engine, the the valve, and its flow goes through the hose intake manifold sucks the blow-by gas through connection in the reverse direction. the P.C.V. valve. On vehicles with an excessively high blow-by Normally, the capacity of the valve is sufficient to some of the flow will go through the hose connec- handle any blow-by and a small amount of venti- tion to the intake collector under all conditions. lating air.

P.C.V. valve operation Engine not running or Cruising backfiringof 5 |: (Ba Acceleration Idling or decelerating or high_load —_ >|»

<= : Fresh air @ : Blow-by gas

P.C.V. valve SEF840K

Inspection P.C.V. (Positive Crankcase Ventilation) With engine running at idle, remove ventilation hose from P.C.V. valve; if the valve is working properly, a hissing noise will be heard as air passes through it and a strong vacuum should be felt immediately when a finger is placed over valve inlet.

SEC137A

VENTILATION HOSE

1. Check hoses and hose connections for leaks.

2. Disconnect all hoses and clean with compressed air. If any hose cannot be freed of obstructions, replace.

ET277

EF & EC-195

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.