Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Assembly (Cont'd)

5. Install pistons with connecting rods. EM03470000 Install them into corresponding cylinders with Tool. a (J8037) e Be careful not to scratch cylinder wall by connecting rod. e Arrange so that front mark on piston head faces toward front of engine. ENibe Ve SEM269C

b. Install connecting rod bearing caps. Tighten connecting rod bearing cap nuts to the specified torque. Connecting rod bearing nut: (1) Tighten to 14 to 16 N-m (1.4 to 1.6 kg-m, 10 to 12 ft-lb). (2) Tighten bolts 60 to 65 degrees clockwise with an angle wrench, or if an angle wrench is not available, tighten them to 38 to 44 N-m (3.9 to 4.5 kg-m, 28 to 33 ft-lb).

6. Measure connecting rod side clearance. Connecting rod side clearance: Standard

0.2 - 0.4 mm (0.008 - 0.016 in) Limit |

0.6 mm (0.024 in) If beyond the limit, replace connecting rod and/or crank- shaft.

$T16610001

REPLACING PILOT BUSHING

(J23907)

1. Remove pilot bushing (M/T) or pilot converter (A/T). or suitable tool

SEM916A

2. Install pilot bushing (M/T) or pilot converter (A/T).

Crankshaft side

AIT SEM163B EM-44

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.