Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Electrical Components Inspection (Cont'd)

VEHICLE SPEED SENSOR

1. Jack up rear wheels. Use stands to support vehicle.

2. Disconnect vehicle speed sensor harness connector.

3. Check continuity between terminals @ and () while rotat- €) ing rear wheel by hand. Continuity should come and go. If N.G. replace vehicle speed sensor.

SEF754H

E.G.R. AND CANISTER CONTROL SOLENOID VALVE,

S.C.V. CONTROL SOLENOID VALVE AND A.1.V. CON-

TROL SOLENOID VALVE

Check air passage continuity.

Air passageAir passage
Conditioncontinuity between (A) andcontinuity between () and ©
12V direct current sup-between (A) andbetween () and ©
ply between terminals @ and @YesNo
@ and @
No supplyNoYes

BATTERY

SEF335H

If N.G., replace solenoid valve.

E.G.R. CONTROL VALVE

E.G.R. control valve Apply vacuum to E.G.R. vacuum port with a hand vacuum pump. E.G.R. control valve spring should lift. If N.G., replace E.G.R. control valve.

SEF820F

B.P.T. VALVE

Plug one of two ports of B.P.T. valve. Apply a pressure above 0.490 kPa (50 mmH,0O, 1.97 inH,O) to check for leakage. If a leak is noted, replace valve.

EC381A

EF & EC-165

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.