Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual

ON-VEHICLE SERVICE

ON-VEHICLE SERVICE

Checking Gear Housing Movement

1. Check the movement of steering gear housing during stationary steering on a dry paved surface. } $m) ie @ Apply a force of 49 N (5 kg, 11 Ib) to steering wheel to check mal () i the gear housing movement. Turn off ignition key while checking. Movement of gear housing: +2 mm (+0.08 in) or less

2. If movement exceeds the limit, replace mount insulator after confirming proper installation of gear housing clamps.

Adjusting Rack Retainer

@ Perform this driving test on a flat road.

a straight line when

1. Check whether vehicle moves in

steering wheel is released.

2. Check whether steering wheel returns to neutral position

when steering wheel is released from a slightly turned (ap-

prox. 20°) position.

@ if any abnormality is found, correct it by resetting adjusting

screw. SST106B

Checking and Adjusting Drive Belts

Refer to section MA for Drive Belt Inspection.

Checking Fluid Level

F) Check fluid level. Fluid level should be checked using ‘“‘HOT” range on dipstick at 176° - fluid temperatures of 50 to 80°C (122 to 176°F) or using “COLD”

range on dipstick at fluid temperatures of 0 to 30°C (32 to 86°F).

§0-80°C (122 HOT: | ~ HOT COLD

CAUTION: @ Do not overfill. O.K. c Recommended fluid is Automatic Transmission Fluid ‘“DEX- @ RONTM” type. SST280B Checking Fluid Leakage Check the lines for improper attachment and for leaks, cracks, damage, loose connections, chafing or deterioration.

1. Run engine at idle speed or 1,000 rpm. Make sure temperature of fluid in oil tank rises to 60 to 80°C (140 to 176°F).

2. Turn steering wheel right-to-left several times.

3. Hold steering wheel at each “lock’’ position for five seconds and carefully check for fluid leakage. S$ST107B

ST-5

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.