TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
TROUBLE DIAGNOSES
TROUBLE DIAGNOSES
Diagnostic Procedure 15 — Engine Stalls when Accelerating or when Driving at
Constant Speed (Cont'd)
a !
M@ FUEL PRES RELEASE
FUEL PUMP WILL STOP BY
N.G. .| Check fuel pump, circuit
TOUCHING START IN IDLING.
CHECK FUEL PRESSURE.
CRANK A FEW TIMES AFTER
| a
1. Perform “FUEL PRESSURE and fuel pressure regula-
ENGINE STALL.
RELEASE” in ‘“‘WORK tor. SUPPORT” mode in order to release fuel pressure to zero.
2. Install fuel pressure gauge START | and check fuel pressure. A few seconds after ignition vy switch is turned OFF to ON: Approx. 294 kPa (3.0 kg/cm?, 43 psi) At idle: Approx. 235 kPa (2.4 kg/cm?, 34 psi) OR
®) (Refer to page EF & EC-171.)
1. Release fuel pressure to zero.
2. Install fuel pressure gauge and check fuel pressure. SEF3791 O.K. Gl Vv
Yes || Discover air leak location
CHECK FOR INTAKE AIR LEAK.
Blow-by | a When pinching blow-by hose (lowering and repair. hose the blow-by air supply), does the en- gine speed rise? No 6 Vv
N.G. || Repair or replace.
CHECK E.C.U. HARNESS CONNECTOR.
Check the E.C.U. pin terminals for dam- SEF300G age or poor connection of E.C.U. har- ness connector. O.K. Vv
Yes || Repair or replace.
CHECK E.C.U. POWER SUPPLY AND
GROUND CIRCUIT.
Refer to page EF & EC-93. No 8] v
TRY A KNOWN GOOD E.C.U.*
Vv
INSPECTION END
*: E.C.U. may be the cause of a problem, but this is rarely the case.
EF & EC-85
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.