Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 12 — Engine Stalls when

an? Engine is Cold

Air regulator

CHECK AIR REGULATOR.

No Check air regulator and Vv When pinching the air regulator hose, circuit. does the engine speed drop? Yes v Yes

CHECK A.A.C. VALVE.

Check A.A.C. valve and Vv When the engine is cold, can you start circuits. (See page EF & SEF963K the engine when pressing accelerator EC-162.) ; pedal fully? No

Fol iy %

¢ 3 ¥ N.G. Go to fe .

PERFORM POWER BALANCE TEST.

Vv

1. Perform ‘POWER BALANCE”’ in “ACTIVE TEST” mode. TM

2. Is there any cylinder which does not produce a momen- tary engine speed drop? OR SEF 1441 (oy When disconnecting each injec- Qs

tor harness connector one at a

[]

mactivetest gw

eS, time, is there any cylinder which

iS

does not produce a momentary

* * & POWER BALANCE * * ®

==>F>== engine speed drop?

===== MONITOR

—_712rpm

CAS-RPM (REF)

AIR FLOW MTR

__‘1.02V O.K.

AAC VALVE

37% 4 ¥ N.G.

Check injector(s) and cir- (Int

CHECK INJECTOR.

- cuit(s).

1. Remove crank angle sensor assem- LL

JL ILLS

bly from engine. (Crank angle sensor harness connector should remain SEF729K connected.) TAL

2. Disconnect ignition coil harness con- DISCONNECT nector.

3. Turn ignition switch ON. (Do not start engine.)

4. When rotating crank angle sensor shaft, does each injector make an operating sound? | O.K. Fuel injector connector / PA // (Go to @ on next page.) SEF738K

SEF837K

EF & EC-77

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.