Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

STARTING SYSTEM — Starter — - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › STARTING SYSTEM — Starter — - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXSTARTING SYSTEM — Starter — - Nissan 240SX 1991-1992 Workshop Manual

STARTING SYSTEM — Starter —

STARTING SYSTEM — Starter —

Magnetic Switch Check

From battery @ Before starting to check, disconnect battery ground cable. @ Disconnect “M” terminal of starter motor. “M” terminal

1. Continuity test (between “S” terminal and switch body). @ No continuity ... Replace.

SELO36H Continuity test (between ‘‘S” terminal and ‘‘M” terminal). From battery @ No continuity ... Replace. “M"’ terminal

Ohmmeter / iw

SELO38H

Pinion/Clutch Check

1. Inspect pinion teeth. @ Replace pinion if teeth are worn or damaged. (Also check condition of ring gear teeth.)

2. Check to see if pinion locks in one direction and rotates smoothly in the opposite direction. @ If it does not lock (or locks) in either direction or unusual resistance is evident. ... Replace.

3. Inspect internal gear teeth.

i SEL630E

@ Replace internal gear if teeth are worn or damaged. (Also check condition of armature shaft gear teeth.)

Brush Check

BRUSH Check wear of brush. Wear limit length: Refer to S.D.S. @ Excessive wear ... Replace. - Vernier caliper Brush

SEL626B

BRUSH SPRING PRESSURE

Check brush spring pressure with brush spring detached from brush. Spring pressure (with new brush): Refer to S.D.S. @ Not within the specified values ... Replace. Brush spring

SEL656M

EL-18

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.