REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
REPAIR FOR COMPONENT PARTS
REPAIR FOR COMPONENT PARTS
Low & Reverse Brake (Cont’d) Low one-way clutch inner race Check frictional surface of inner race for wear or damage.
|
SAT877A Install a new seal rings onto low one-way clutch inner race. Clearance _. Be careful not to expand seal ring gap excessively. Seal ring Measure seal ring-to-groove clearance. Inspection standard: Standard value: 0.10 - 0.25 mm (0.0039 - 0.0098 in) Allowable limit: 0.25 mm (0.0098 in) If not within allowable limit, replace low one-way clutch inner race.
- SAT878A ASSEMBLY Install bearing onto one-way clutch inner race.
1.
Pay attention to its direction — Black surface goes to rear
@ side. Apply petroleum jelly to needle bearing.
SAT112B Install oil seal and D-ring onto piston. NO Apply A.T.F. to oil seal and D-ring.
9 SAT879A Install piston by rotating it slowly and evenly.
3. Apply A.T.F. to inner surface of transmission case. e
AT-152
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.