DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › DISCHARGING, EVACUATING, CHARGING AND CHECKING - Nissan 240SX 1991-1992 Workshop Manual
DISCHARGING, EVACUATING, CHARGING AND CHECKING
DISCHARGING, EVACUATING, CHARGING AND CHECKING
Inspection for Refrigerant Leaks
WORK PROCEDURE
To facilitate inspection for refrigerant leaks, establish the following conditions: Start the engine. e Run the air conditioner. Set the blower fan control to MAX. Set the temperature control to FULL COLD. Run the refrigerant system for more than 5 minutes after setting the above-mentioned conditions (to circulate the refrigerant through the system).
Refrigerant leaks should be checked immediately after stopping the engine, beginning with the high pressure line, using a gas Pressure in high
leak detector. This is because the pressure in the high pressure
Pressureuine line drops gradually after the refrigerant circulation stops while the pressure in the low pressure line rises gradually as shown Pressure in the graph. Leaks can be detected easily when pressure is
__/ Pressure in low
high. -_- ————oo . pressure line | ~ . t Tim Compressor stops. me RHA604B To prevent detecting errors, make sure that there is no refrig- erant vapor or tobacco smoke in the vicinity of the vehicle. It is also necessary to shield the vehicle from the wind so that the leaking refrigerant is not blown away.
HA-34
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.