Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREPAIR FOR COMPONENT PARTS - Nissan 240SX 1991-1992 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

Reverse Clutch (Cont'd)

3. Remove drive plates, driven plates, retaining plate, dish plate and snap ring.

SAT842A

4. Remove snap ring from clutch drum while compressing KV31102400 (J34285 and clutch springs. J34285-87) @ Do not expand snap ring excessively.

5. Remove spring retainer and return spring.

SAT843A

6. Install seal ring onto oil pump cover and install reverse clutch drum. While holding piston, gradually apply com- pressed air to oil hole until piston is removed. @ Do not apply compressed air abruptly.

7. Remove D-ring and oil seal from piston. INSPECTION Reverse clutch snap ring and spring retainer @ Check for deformation, fatigue or damage. SAT844A Reverse clutch return springs @ Check for deformation or damage. Also measure free length and outside diameter. diameter Inspection standard: Outer : D Q : Free length

Unit: mm (in)
PartsPart No.QD
Spring31505-41 X0219.69 (0.7752)11.6 (0.457)

SAT829A Reverse clutch drive plates Thickness @ Check facing for burns, cracks or damage. @ Measure thickness of facing. Thickness of drive plate: Facing Standard value: 2.0 mm (0.079 in) Wear limit: 1.8 mm (0.071 in) @ If not within wear limit, replace. Core plat e Reverse clutch dish plate @ Check for deformation or damage. SAT845A AT-141

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.