REAR DISC BRAKE (CL9H) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › REAR DISC BRAKE (CL9H) - Nissan 240SX 1991-1992 Workshop Manual
REAR DISC BRAKE (CL9H)
REAR DISC BRAKE (CL9H)
Disassembly (Cont'd)
4. Remove return spring and lever.
SBR877 Inspection
CYLINDER BODY
@ Check inside surface of cylinder for score, rust, wear or other damage. @ Minor damage from rust of foreign materials may be elimi- nated by polishing surface with a fine emery paper. Replace if necessary.
CAUTION: Use brake fluid to clean.
TORQUE MEMBER
Check for wear, cracks or other damage. Replace if necessary. PISTON Check piston for score, rust, wear or other damage. Replace if necessary.
CAUTION: Piston sliding surface is plated. Do not polish with emery paper even if rust or foreign matter is stuck to sliding surface.
PIN AND PIN BOOT
Check for wear, cracks or other damage. Replace if necessary. Assembly @ Install cup securely in the specified direction.
Adjusting nut SBR849 @ Fit push rod into square hole in key plate. Also match convex portion of key plate with concave portion of cylinder.
Convex portion
SBR893 |
BR-18
Parts & tools for this job For Nissan 240SX
- PARTRear brake padsSearch: Nissan 240SX rear brake pads
- TOOLCaliper piston rewind toolSearch: brake caliper piston rewind tool
- FLUIDBrake fluidSearch: brake fluid
As an Amazon Associate we earn from qualifying purchases.