Installation (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Installation (Cont'd) - Nissan 240SX 1991-1992 Workshop Manual
Installation (Cont'd)
FRONT AXLE — Wheel Hub and Knuckle
Installation (Cont'd)
@ Check wheel bearing axial end play. Axial end play: 0.03 mm (0.0012 in) or less
Disassembly
CAUTION: Suitable tool When removing wheel bearing from wheel hub, replace wheel bearing assembly (outer race, inner races and grease seal) with a new one. @ Remove circular clip with suitable tool.
SFA824A @ Press out wheel bearing assembly from wheel hub.
Inspection
WHEEL HUB
Check wheel hub for any cracks by using a magnetic exploration or dyeing test.
CIRCULAR CLIP
Check circular clip for wear or cracks. Replace if necessary.
Assembly
1. Press new wheel bearing assembly into wheel hub from inside of wheel hub. Maximum load P:
IN Grease seal
29 KN (3 t, 3.3 US ton, 3.0 Imp ton)
CAUTION: Wheel bearing @ Do not press inner race of wheel bearing assembly. assembly @ Do not apply oil or grease to mating surfaces of wheel bearing outer race and wheel hub. Be careful not to damage grease seal. ZZ Zo SFA217A
FA-11
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.